BASIC (F) (EN)
One layer of Gyproc WallBoard 15mm on Gyproc DriWall Adhesive dabs (10mm nominal cavity) on solid smooth concrete
Read more
Read less
Products
| Board side 1 | Layer 1: Gyproc WallBoard 15mm |
| Fixing method | Gyproc DriWall Adhesive |
| Thermal sealant | Gyproc DriWall Adhesive |
| Parge coat | Gyproc SoundCoat Plus |
Details
This section should be read in conjunction with the Products list.
- Background: Smooth concrete
- Finishing Requirements: The system should be finished using either one of our Thistle or ThistlePro plasters, or Gyproc jointing products. See the product range guides on the British Gypsum website for more information.
- Loadbearing: No
- Other Requirements: SpecSure® system performance warranty confirms that British Gypsum proprietary systems will perform as specified for the lifetime of the building. The SpecSure® warranty requires that all components are specified in full and constructed in accordance with British Gypsum’s installation guidance. For more details see the British Gypsum website. Always check with the design team before making any changes to the chosen specification, ensuring appropriate substantiation is sought to confirm that the solution still meets all required project performances.
- Sealant: Locate sealant at junctions with adjoining structure and other air paths. Apply as a continuous bead to clean, dry, dust-free surfaces, leaving no gaps. After application of sealant, bulk fill gaps between floor and underside of plasterboard using Gyproc jointing compound.
- Minimum Cavity / Offset (mm): 10 mm
- Fixing Method: Apply dabs of adhesive to the background for one board at a time, to achieve at least 20% contact with the surface area of the boards. One row of horizontal dabs to coincide with the top edge of each board. One continuous line of horizontal dabs to coincide with the bottom edge of each board. One row of vertical dabs to coincide with the side edges of each board, and additional vertical row(s) at 600mm maximum centres for boards 15mm thick x 1200mm wide and 450mm maximum centres for boards 15mm thick x 900mm wide. Ensure dabs are at least 25mm from board edges. For linings to receive ceramic finishes, apply one additional row of dabs at mid storey height.
- Framework / Lining: One Side
- Parge Coat: If required apply a parge coat at least 6mm thick to the entire surface of the background ensuring all cracked or unfilled joints are covered. Allow to set before following on with plasterboard installation.
- Thermal Sealant: Before/during installation of dry lining system, fully seal all airpaths around the perimeter of the background and around structural openings and service penetrations through the background using adhesive. Apply as a continuous fillet, leaving no gaps.
Documents
Need CAD, BIM, Test Reports and Technical Specifications?
Log in to access CAD .dwg files.
Log in and add a System Specification to a Project to access BIM files, Test Reports, and Technical Specification files.
Image
SpecSure
A unique warranty that confirms British Gypsum proprietary systems will perform as specified for the lifetime of the building.