FAQs

We offer a wide range of ceiling systems such as GypCeiling MF and GypCeiling Lining, incorporating Gyproc SoundBloc or Gyproc FireLine board in conjunction with Isover insulation.

Another option is Gypframe RB1 Resilient Bar fixed direct to the underside of the floor joists.

We offer several system options for doing this, selection will depend on factors such as type of background, height of lining and performance required. 

The solutions commonly used are Gyproc SoundBloc plasterboard and Isover insulation with the GypLyner Independent or GypLyner Single systems.

First, the existing lath and plaster ceiling should be fully retained with suitable reinforcing, for example, chicken wire, which should be designed and fixed in accordance with guidance from a structural engineer based on the calculated weight of the existing ceiling. This is to prevent a situation where an old ceiling falls onto the new GypCeiling lining, therefore, adding additional weight which the new system is not capable of supporting.

The DriLyner Dab system is ideal for concrete surfaces that are stable and free of release agents.

Our FireCase system can be used to provide fire protection to steel columns within a masonry wall.

The thickness of Glasroc F FireCase board to be applied will depend on the section factor of the structural steel (A/V), if you need help with calculating this please get in touch with us by filling out the Technical Enquiry Form.

For wall constructions the Gypframe GL1 Lining Channels are located at 600mm centres and Gypframe GL2 Brackets or Gypframe GL9 Brackets are located at 800mm centres (based upon not receiving ceramic tiles).

For ceiling constructions the Gypframe GL1 Lining Channels are located at 450mm (for 12.5mm lining) or 600mm centres (for 15mm lining) and Gypframe GL2 Brackets, Gypframe GL9 Brackets or Gypframe GL12 Brackets are located at 1200mm centres.

In general terms for partitions, screws are located at 300mm centres (200mm centres at external angles). For ceiling systems, the screws are located at 230mm centres within the field of the board and 150mm centres at board ends. For encasement systems, screws are located at 150mm centres.

However, these general guidelines may vary depending upon the system being used so always check against specific systems for your reference.

Fire resistance performance is based on complete ‘elements’ such as a partition, wall, ceiling membrane or floor, rather than the individual plasterboards that only form part of these constructions.

A secondary GypCeiling MF ceiling can be supported from Gypframe FEA1 Steel Angle (fixed through to the Gypframe MF5 Ceiling Section above).

With Gypframe MF8 Strap Hanger or Gypframe FEA1 Steel Angle used to suspend the ceiling below.