Image

FAQs

Below you’ll find all of the information needed to complete wall lining, partition, floor and ceiling systems, no matter the size and complexity of the project specification.
Filter your results
Product/System Performance
6 results

Can I reduce stud centres to increase the maximum height of a partition?

For partitions where no fire rating is required, or where specified to BS 476: Part 22, the maximum system height is limited to the cold state height (L/240@200Pa.) Refer to the following Technical Guidance Note.

View more

How do you achieve a fire-rated timber stud partition?

Using different combinations of board and insulation, various system options are available with fire resistance periods of 30, 60, 90 or 120 minutes. Use the Technical Enquiry Form in the Technical Support area of the website to request information for your specific requirements.

View more

What is the fire resistance performance of Gyproc plasterboard?

Fire resistance performance is based on complete ‘elements’ such as a partition, wall, ceiling membrane or floor, rather than the individual plasterboards that only form part of these constructions.

View more

How do you build a fire-rated partition where access is limited to one side only?

Our GypWall Shaft system is designed for this application.

View more

How do you fire protect structural steel sections?

We offer the FireCase system or the GypLyner Encase system to form an encasement around the beam or column.

View more